To configure your AudioCodes MP-11x device, you will need a computer (to access the web based configuration).
Note: AudioCodes devices are some of the most complicated to configure.
- Connect to your AudioCodes device.
- On the left, under the tab "Configuration", click on “Full”.
Then, select:
– "VoIP"
– "SIP Definitions"
– "Proxy & Registration"
- Enter the following data
(as provided in your activation email and in the Device Settings page of the User Portal):
- Always User Proxy: Enable
- Enable Registration: Enable
- Registrar Name: VoIPMuch
- Registrar IP Address: [SIP Server]
- Subscription Mode: Per Endpoint
- Registration Mode: Per Endpoint![](/Management/KnowledgeBase/frmAttachment.aspx?kbattchid=84)
- Click Submit.
- On the left, under the tab "Configuration", click on “Full”.
Then, select:
– "VoIP"
– "SIP Definitions"
– "General Parameters"
- Enter the following data
- NAT IP Address: [if your hardware is behind NAT, then specify your external IP address]
- Fax Signaling Method: T.38 Relay
- SIP UDP Local Port: 55060
- SIP Destination Port: 5060
![](/Management/KnowledgeBase/frmAttachment.aspx?kbattchid=81)
Click Submit.
On the left, under the tab "Configuration", click on “Full”.
Then, select:
– "VoIP"
– "Coders and Profiles"
– "Codes"
Enter the following data:
-
Select Coder name: G.711U-law
-
Packetization: 20
-
Rate: 64
-
Payload: 8
-
Silence: Disabled
![](/Management/KnowledgeBase/frmAttachment.aspx?kbattchid=85)
Click Submit.
On the left, under the tab "Configuration", click on “Full”.
Then, select:
– "VoIP"
– "GW and IP to IP"
– "Hunt Group"
- "Endpoint Phone Number"
Enter the following data:
-
Channel: 1
-
Phone Number: SIP Username
(as provided in your activation email and in the Device Settings page of the User Portal)
![](/Management/KnowledgeBase/frmAttachment.aspx?kbattchid=86)
Click Submit.
On the left, under the tab "Configuration", click on “Full”.
Then, select:
– "VoIP"
– "Routing"
– "Tel to IP Routing"
Enter the following data on Src Trunk Group ID 1:
-
Dest IP Address: SIP Server
(as provided in your activation email and in the Device Settings page of the User Portal)
-
Port: 5060
-
Transport: UDP
![](/Management/KnowledgeBase/frmAttachment.aspx?kbattchid=87)
Click Submit.
On the left, under the tab "Configuration", click on “Full”.
Then, select:
– "VoIP"
– "GW and IP to IP"
– "Analog Gateway"
- "Authentication
Enter the following data
(as provided in your activation email and in the Device Settings page of the User Portal):
-
User Name: SIP Username
-
Password: SIP Password
![](/Management/KnowledgeBase/frmAttachment.aspx?kbattchid=82)
Click Submit.
In the next window that appears click on "OK" to “burn” data into device's memory
- Click on “
Burn”.
![](/Management/KnowledgeBase/frmAttachment.aspx?kbattchid=83)
Congratulations, your done!
Article ID: 179, Created: 2/6/2024 at 9:28 PM, Modified: 2/6/2024 at 9:28 PM